Causes and troubleshooting of universal crusher blockage

The clogging of the universal pulverizer is one of the common faults in the use of the pulverizer. It may be a problem in the design of the organic tool, but it is more caused by improper operation.

(1) The feed rate is too fast, the load is increased, causing blockage
In the feeding process, always pay attention to the current table pointer deflection angle is large, if the rated current is exceeded, (if it is a product without current meter, pay attention to the sound of the head and the motor working normally, abnormal noise occurs) indicates that the motor is overloaded and overloaded for a long time. Will burn the motor. In this case, the door should be immediately reduced or closed, and the way of feeding can be changed. The feeder is controlled to increase the amount of feed. There are two types of feeders: manual and automatic. Users should select the appropriate feeder according to the actual situation. Because the universal shredder has high speed and load, and the load is highly volatile. Therefore, the current when the pulverizer is working is generally controlled at about 85% of the rated current.
(2) The discharge pipe is not smooth or blocked
If the feed is too fast, the air vent of the universal crusher will be blocked; improper matching with the conveying equipment will cause the wind of the discharge pipe to be weakened or blocked after no wind; if the bag dust-removing product does not pay attention to cleaning the bag regularly, it will easily cause the air volume of the draft fan. Blocked after weakening or no wind. After the fault is detected, the conveying equipment whose delivery port is not matched shall be cleared first, and the feeding amount shall be adjusted to make the equipment operate normally.
(3) The claws or hammer fragments, aging, screen mesh holes are closed, broken, and the water content of the crushed material is too high, which will make the universal crusher clog
The broken or severely aged claws or hammers should be regularly updated to keep the pulverizer in good working condition, and the screen should be inspected regularly. The moisture content of the pulverized material should be less than 14%, which can improve the production efficiency and make the universal crushing. The machine is not blocked, which enhances the reliability of the work of the crusher.